Keysight Technologies B1507A, User Manual

Page: 156 / 190

4- 48 Keysight B1507A User’s Guide, Edition 1
GUI Reference
I/V Measurement Software
You can change the settings of this terminal using the pull-down menu. For
details, see “Resource/Output Mode/Output Sequence” on page 4-50.
• Number of Step
Specify the number of sweep steps from start to stop.
• Compliance
Specify a current/voltage compliance value.

If the output exceeds this, the sweep measurement is terminated.
• Power Compliance
Specify the power compliance value.

To enable this, mark the check box.

If the output exceeds this, the sweep measurement is terminated.

Not available for HVSMU.
• Voltage Compliance
Specify a voltage compliance value for UHCU.

To enable this, mark the check box.

If the output exceeds this, the sweep measurement is terminated.

Available for UHCU.
Pulse Sweep
The terminal outputs the staircase-swept pulse voltage/current.
Set the following parameters.
• Sweep Mode
Select one from the following sweep modes.
• LinearSingle (Sweep from start to stop in a linear incremental step)
• LogSingle (Sweep from start to stop in a logarithmic incremental step)
• LinearDouble (Sweep from start to stop to start in a linear incremental step)
• LogDouble (Sweep from start to stop to start in a logarithmic incremental
step)
• Start
Specify the sweep start value.
• Stop
Specify the sweep stop value.