Keysight Technologies B1507A, User Manual

Page: 119 / 190

Keysight B1507A User’s Guide, Edition 1 4- 11
GUI Reference
Capacitance Measurement Software
Work Area
In this area, set the measurement conditions and observe the measurement results.
This is separated to the following areas.
• “Setup” on page 4-11
• “Characteristics” on page 4-20
• “Connections” on page 4-24
Setup
Figure 4-4 Setup
This is an area to select the device type and its measured parameters, and enter your
measurement conditions.
Device Type
Select the device type of your DUT from below.
• “MOSFET”
• “IGBT”
• “Diode”
• “Generic”
Select Generic to execute more general measurements for device other than
above types.
MOSFET
You can select one of the following capacitance and resistance parameter
measurements for “MOSFET” device type.
• Ciss, Coss, Crss
Creates new settings to measure the characteristics of the input capacitance,
output capacitance, and reverse transfer capacitance for the drain-source voltage
in order.
• Ciss
Creates new settings to measure the characteristics of the input capacitance for
the drain-source voltage.