![background image](http://html1.mh-extra.com/html/keithley/4200-scs/4200-scs_user-manual_3981678075.webp)
4200-900-01 Rev. K / February 2017
Return to
2-19
Model 4200-SCS User’s Manual
Section 2: Model 4200-SCS Software Environment
Figure 2-10
Instrument information, forcing functions, and voltage sweep function parameters
1
Do not change these parameters, unless you want to customize the ITM — which is beyond the scope of this User’s manual.
2
Dual sweep – with dual sweep enabled, the SMU will sweep from start to stop, and then sweep from stop back to start. When disabled, the SMU will sweep
from start to stop. For details, see
Understanding dual sweep on page 2-15
.
Figure 2-11
Linear sweep or step, SMU range, Pulse Mode, and SMU current compliance
3
In a list sweep configuration window, you enter a list of discrete voltages or currents, instead of start, stop, and step values. In a current bias or voltage bias
configuration window, you enter a fixed level value, instead of start, stop, and step values.
4
Pulse mode – Select
Pulse Mode
to provide pulse output for sweep (linear, log and list) and bias forcing functions. For details, see
Describes the instrument selected for
this device terminal and the mode of the
test being performed. (Sweeping mode
or Sampling mode — in which data is
recorded vs. time for an applied signal).
Select whether a sweep or
step forcing function acts as
a master (independent) or
slave (tracks the master).
1
Select the present forcing
function.
1
Select Dual Sweep.
2
Select whether a sweep is
linear or logarithmic.
1
For a
Linear
sweep
or
step
Start
is the voltage / current at the start
of the sweep,
Stop
is the voltage / current at the end of the sweep,
and
Step
is the voltage / current change between steps.
3
Data
Points
— calculated automatically from the
Start
,
Stop
, and
Step
values — is disabled. For a
Log
sweep, you specify the
Data Points
value. The
Step
value — calculated automatically — is disabled.
Select the SMU
range to be used
when forcing the
specified voltage
or current. Select
dynamically opti-
mized range
(Auto), single best
range for entire
sweep (Best
Fixed), or manually
specified numeri-
cal range.
Select and configure
Pulse Mode.
4
Select the SMU current compliance for a
voltage sweep or the voltage compliance
for a current sweep.
Summary of Contents for 4200-SCS
Page 2: ......
Page 4: ......
Page 334: ...Index 6 4200 900 01 Rev K February 2017 Model 4200 SCS User s Manual Index...