Juniper JUNOSE, Configuration Manual

Page: 689 / 738

d. Activate the neighbors in the L2VPN address family for the PE-to-PE BGP
session.
e. Create the VPWS address family to configure the router to exchange layer
2 NLRI for each VPWS instance configured on the router.
6.
Configure MPLS label-switched paths (LSPs) to connect the local and remote PE
routers.
a. Enable MPLS on the virtual router.
b. Configure the core-facing interface on which you want to enable MPLS, Label
Distribution Protocol (LDP), and topology-driven LSPs.
c. Enable MPLS on the core-facing interface.
d. Enable LDP and topology-driven LSPs on the core-facing interface.
Related Topics
■
Configuring BGP Signaling for VPWS on page 658
■
Configuring a Local Cross-Connect for VPWS on page 656
■
Configuring a VPWS Instance on page 653
■
Configuring Customer-Facing Interfaces in the VPWS Instance on page 655
■
Configuring the Loopback Interface and Router ID for BGP for VPWS on page 657
■
Configuring MPLS LSPs for VPWS on page 659
■
For a detailed sample configuration, see VPWS Configuration Example on page 660
Configuring a VPWS Instance
You must configure a VPWS instance for each L2VPN in which the router participates.
From a configuration standpoint, a VPWS instance is simply a new L2VPN that you
configure with additional VPWS L2VPN attributes.
Table 100 on page 653 lists the commands that you use to configure a basic VPWS
instance.
Table 100: Commands to Configure Basic VPWS Instances
l2vpn route-target l2vpn control-word
l2vpn sequencing l2vpn encapsulation-type
l2vpn site-name site-id l2vpn local-site-id remote-site-id
l2vpn site-range l2vpn rd
To configure a basic VPWS instance on the PE router:
Configuring a VPWS Instance
■ 653
Chapter 13: Configuring VPWS