Juniper JUNOSE, Configuration Manual

Page: 311 / 738

When an endpoint is dynamically learned from the specified routing protocol, MPLS
searches its tunnel profiles for a match. The dynamic tunnel is established using the
settings from the first matching profile.
Related Topics
■
MPLS Global Configuration Tasks on page 265
■
MPLS Interface Configuration Tasks on page 270
■
MPLS Tunnel Configuration Tasks on page 272
■
MPLS Tunnel Profile Configuration Tasks on page 273
■
Additional LDP Configuration Tasks on page 277
■
Additional RSVP-TE Configuration Tasks on page 282
■
mpls tunnels profile
■
tunnel destination
■
tunnel mpls affinity
■
tunnel mpls autoroute announce
■
tunnel mpls autoroute metric
■
tunnel mpls bandwidth
■
tunnel mpls description
■
tunnel mpls no-route retries
■
tunnel mpls no-route retry-time
■
tunnel mpls path-option
■
tunnel mpls priority
■
tunnel mpls retries
■
tunnel mpls retry-time
Configuring Explicit Routing for MPLS
When you configure explicit routing rather than hop-by-hop routing for MPLS, the
route the LSP takes is defined by the ingress node. The path consists of a series of
hops defined by the ingress LSR. Each hop can be a traditional interface, an
autonomous system, or an LSP.
MPLS explicit routing configuration tasks include the following sets of tasks:
■
Defining Configured Explicit Paths on page 276
■
Specifying Configured Explicit Paths on a Tunnel on page 276
■
Configuring Dynamic Explicit Paths on a Tunnel on page 277
Configuring Explicit Routing for MPLS
■ 275
Chapter 3: Configuring MPLS