Juniper JUNOSE, Configuration Manual

Page: 347 / 738

Chapter 4
Monitoring MPLS
This chapter describes the commands you can use to monitor and troubleshoot
Multiprotocol Label Switching (MPLS) on E Series routers.
NOTE: The E120 and E320 Broadband Services Routers output for monitor and
show commands is identical to output from other E Series routers, except that the
E120 and E320 router output also includes information about the adapter identifier
in the interface specifier (
slot / adapter / port ).
This chapter contains the following sections:
■
Setting the Baseline for MPLS Statistics on page 312
■
Clearing and Re-Creating Dynamic Interfaces from MPLS Major
Interfaces on page 315
■
Clearing and Refreshing IPv4 Dynamic Routes in the Tunnel Routing
Table on page 315
■
Clearing and Refreshing IPv6 Dynamic Routes in the Tunnel Routing
Table on page 315
■
Tracing Paths Through the MPLS User Plane on page 316
■
Monitoring ATM VCs and VPI/VCI Ranges Used for MPLS on page 316
■
Monitoring Global Call Admission Control Configuration on page 318
■
Monitoring Interfaces Configured with Traffic Engineering Bandwidth
Accounting on page 318
■
Monitoring Virtual Router Configuration on page 319
■
Monitoring IP and IPv6 Tunnel Routing Tables on page 319
■
Monitoring LDP on page 321
■
Monitoring MPLS Label Bindings on page 323
■
Monitoring LDP Graceful Restart on page 324
■
Monitoring Interfaces That are Synchronizing with LDP on page 325
■
Monitoring LDP Interfaces on page 326
■
Monitoring LDP Neighbors on page 328
■
Monitoring LDP Profiles on page 330
■
Monitoring LDP Statistics on page 331
■ 311