Juniper JUNOSE, Configuration Manual

Page: 312 / 738

Defining Configured Explicit Paths
You can create explicit routing paths manually by configuring an explicit path with
a name and a series of addresses (hops) from ingress to egress.
To manually configure explicit routing:
1.
Define an explicit path and access Explicit Path Configuration mode.
host1(config)# mpls explicit-path name xyz
host1(config-expl-path)#
2.
Do one of the following to configure the hops in the LSP:
■
Set the next hop (if need be) at a particular index in the explicit path.
host1(config-expl-path)# index 5 next-address 172.18.100.5
■
Add the next hop (if need be) after a particular index in the explicit path.
host1(config-expl-path)# append-after 5 next-address 192.168.47.22
3.
Configure a next hop at the end of the MPLS explicit path.
host1(config-expl-path)# next-address 10.10.9.2
4.
Enable the explicit path.
host1(config)# mpls explicit-path name xyz
NOTE: To prevent a partially configured explicit path from being used, do not enable
it until you have finished configuring or modifying the path.
5.
(Optional) List the currently configured explicit path.
host1(config-expl-path)# list 5
Specifying Configured Explicit Paths on a Tunnel
After you have defined a configured explicit path, you can configure the path on a
tunnel.
To configure explicit routing on a tunnel:
1.
Create an MPLS tunnel.
host1(config)# interface tunnel mpls:1
2.
Set the path option.
host1(config-if)# tunnel mpls path-option 1 explicit name xyz
276 ■
Defining Configured Explicit Paths
JUNOSe 11.0.x BGP and MPLS Configuration Guide