Juniper JUNOSE, Configuration Manual

Page: 542 / 738

■
Encapsulation Methods for Transport of PPP/HDLC Over IP and MPLS
Networks—draft-ietf-pwe3-hdlc-ppp-encap-mpls-03.txt (October 2004 expiration)
■
Framework for Pseudo Wire Emulation Edge-to-Edge
(PWE3)—draft-ietf-pwe3-arch-06.txt (April 2004 expiration)
■
IEEE 802.3ad (Link Aggregation)
■
Pseudowire Setup and Maintenance Using
LDP—draft-ietf-pwe3-control-protocol-08.txt (January 2005 expiration)
■
Requirements for Pseudo-Wire Emulation Edge-to-Edge
(PWE3)—draft-ietf-pwe3-requirements-08.txt (June 2004 expiration)
■
Transport of Layer 2 Frames Over MPLS—draft-martini-12circuit-trans-mpls-11.txt
(October 2003 expiration)
NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must
be considered as works in progress. Please refer to the IETF Web site at
http://www.ietf.org for the latest drafts.
For information about configuring supported layer 2 interfaces, consult the following
resources:
■
JUNOSe Physical Layer Configuration Guide
■
See Configuring ATM in JUNOSe Link Layer Configuration Guide .
■
See Configuring Frame Relay in JUNOSe Link Layer Configuration Guide .
■
See Configuring Packet over SONET in JUNOSe Link Layer Configuration Guide .
■
See Configuring Bridged Ethernet in JUNOSe Link Layer Configuration Guide .
For information about configuring supported serial interfaces, which are also referred
to as HDLC channels, see the following resources:
■
See Configuring Channelized T3 Interfaces in JUNOSe Physical Layer Configuration
Guide .
■
See Configuring T3 and E3 in JUNOSe Physical Layer Configuration Guide .
■
See Configuring Channelized OCx/STMx Interfaces in JUNOSe Physical Layer
Configuration Guide .
For information about configuring MPLS, see “Configuring MPLS” on page 263.
Layer 2 Services over MPLS Implementation
When layer 2 services are configured over MPLS, layer 2 traffic is encapsulated in
MPLS frames and sent over MPLS tunnels. A virtual circuit (VC) label that indicates
a specific layer 2 connection, such as a Frame Relay data-link connection identifier
(DLCI), is pushed into the label stack between the tunnel label and the layer 2 data.
506 ■
Layer 2 Services over MPLS Implementation
JUNOSe 11.0.x BGP and MPLS Configuration Guide