Juniper JUNOSE, Configuration Manual

Page: 371 / 738

Topology Driven LSP enabled
LSPs used for IP forwarding
for host addresses only
Additional detail is shown when RSVP-TE is enabled:
RSVP is enabled
LSRID 10.1.1.1
Re-optimization timer is 3600
Tunnel retry forever at interval 5 if route is available
Tunnel retry forever at interval 5 if no route is available
Refresh reduction is OFF
Message bundling is OFF
Egress label is non-null
Hellos are on with an interval of 10000 and miss limit of 4
Graceful restart is ON
Restart time 60000 milliseconds
Recovery time 120000 milliseconds
■
Additional detail shown when RSVP-TE graceful restart helper mode is enabled:
RSVP is enabled
...
Graceful restart is ON (helper mode)
Meaning
Table 44 on page 335 lists the show mpls command output fields.
Table 44: show mpls Output Fields
Field Description Field Name
Status of MPLS, administratively enabled or disabled, and
configuration status MPLS
IP address of label-switched router LSR ID
Frequency at which LSPs are checked for better paths Re-optimization timer
Range of platform label space Label range
Retry behavior to be performed during LSP setup retry
Status of loop detection, enabled or disabled Loop Detect
This field and the following fields are displayed only when LDP is
enabled. LDP
IP address of label-switched router LSR ID
State of FEC deaggregation, on or off FEC Deaggregation
Type of label advertised for the LSR that is the egress router for
the prefix, explicit-null or a non-null label Egress label
Label distribution control mode used by LDP for label distribution,
independent control or ordered control Label distribution control
mode
Monitoring MPLS Status and Configuration
■ 335
Chapter 4: Monitoring MPLS