Juniper JUNOSE, Configuration Manual

Page: 358 / 738

NOTE: The mpls keyword is optional and is provided for compatibility with non–E
Series implementations.
Meaning
Table 35 on page 322 lists the show ldp command output fields.
Table 35: show ldp Output Fields
Field Description Field Name
IP address of label-switched router LSR ID
State of FEC deaggregation, on or off FEC Deaggregation
Type of label advertised for the LSR that is the egress router for
the prefix, implicit null, explicit null, or a non-null label Egress label
Label distribution control mode used by LDP for label distribution,
independent control, or ordered control Label distribution control
mode
Configured values for the number of LDP session retry attempts
and the retry interval LDP session retry
Configured value for the LDP session hold time LDP session hold time
Interval at which LDP sends session keepalive messages, in seconds LDP session keepalive
interval
LDP targeted-hello hold time, in seconds LDP targeted-hello hold
time
LDP targeted-hello interval, in seconds LDP targeted-hello interval
Status of topology-driven LSP, enabled or disabled Topology Driven LSP
LSPs are placed in the IP routing table for forwarding plain IP traffic;
displayed only when the
mpls ldp ip-forwarding command has
been configured. Indicates whether the LSPs that are used for IP
forwarding are host only, subject to a specified access list, or subject
to a specified prefix list.
LSPs used for IP forwarding
LDP protocol statistics LDP proto stats
Number of LDP peers discovered totalPeersDiscovered
Number of LDP adjacencies established totalAdjacenciesEstablished
Number of LDP sessions established totalSessionsEstablished
Number of FEC elements totalFECElements
Number of FECs totalFECs
Number of in labels (sent to upstream neighbor) totalInLabels
322 ■
Monitoring LDP
JUNOSe 11.0.x BGP and MPLS Configuration Guide