Juniper JUNOSE, Configuration Manual

Page: 372 / 738

Table 44: show mpls Output Fields (continued)
Field Description Field Name
Interval in seconds between attempts to set up an MPLS LDP
session LDP session retry
Period in seconds for which an LSR maintains the session with its
LDP peer without receipt of any LDP message from that peer LDP session hold time
Interval at which LDP sends session keepalive messages, in seconds LDP session keepalive
interval
LDP targeted-hello hold time, in seconds LDP targeted hello hold
time
LDP targeted-hello interval, in seconds LDP targeted-hello interval
Status of topology-driven LSP, enabled or disabled Topology Driven LSP
LSPs are placed in the IP routing table for forwarding plain IP traffic;
displayed only when the
mpls ldp ip-forwarding command has
been configured. Indicates whether the LSPs that are used for IP
forwarding are host only, subject to a specified access list, or subject
to a specified prefix list.
LSPs used for IP forwarding
This field and the following fields are displayed only when RSVP-TE
is enabled. RSVP is enabled
IP address of label-switched router LSRID
Frequency at which LSPs are checked for better paths Re-optimization timer
Retry behavior to be performed during LSP setup Tunnel retry
State of RSVP-TE summary refresh reduction, OFF or ON Refresh reduction
State of RSVP-TE summary refresh message bundling, OFF or ON Message bundling
Type of label advertised for the LSR that is the egress router for
the prefix, explicit-null or a non-null label Egress label
State of RSVP-TE hello feature, including the hello refresh interval
and hello miss limit Hellos
State of RSVP-TE graceful restart, OFF or ON Graceful restart
Graceful restart helper mode is enabled when this field is displayed helper mode
Graceful restart time, in milliseconds Restart time
Graceful restart recovery time, in milliseconds Recovery time
336 ■
Monitoring MPLS Status and Configuration
JUNOSe 11.0.x BGP and MPLS Configuration Guide