Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 47 / 262

■
Use the no version to restore the default value, 16.
■
See crc.
idle-character
■
Use to configure the HDLC idle character.
■
The idle character is sent between HDLC packets.
■
Specify one of the following idle characters:
■
flags— Sets the idle character to 0x7E
■
marks —Sets the idle character to 0xFF
■
Example
host1(config-if)# idle-character marks
■
Use the no version to restore the default value, 0x7E (flags).
■
See idle-character.
interface serial
Use to configure a serial interface in the slot/port:channel/subchannel format.
■
■
slot —Number of the slot in which the line module resides in the chassis
■
port —Number of the port on the I/O module
■
channel —T1 channel
■
subchannel —Subchannel in the range 1–24
■
Example
host1(config)# interface serial 0/1:1/5
■
Use the no version to disable the interface.
■
See interface serial.
invert data
■
Use to enable data stream inversion for the interface.
■
Enable data stream inversion only if it is turned on at the other end of the line.
■
Example
host1(config-if)# invert data
■
Use the no version to disable data inversion.
■
See invert data.
load-interval
Configuration Tasks
■ 21
Chapter 1: Configuring Channelized T3 Interfaces