Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 40 / 262

■
Use to configure the framing format for a T3 controller.
■
Specify either m23 or c-bit framing.
■
Choose the framing format that is compatible with the framing format of the
Telco network device at the other end of the line.
■
Select c-bit framing if you intend to configure MDL messages.
■
Example
host1(config-controll)# framing c-bit
■
Use the no version to restore the default value, c-bit .
■
See framing.
snmp trap ip link-status
■
Use to enable SNMP link status processing on a T3 controller.
■
Example
host1(config-controll)# snmp trap link-status
■
Use the no version to disable SNMP link status processing.
■
See snmp trap ip link-status.
Configuring T1 Channels
To configure T1 channels and subchannels:
1.
From Global Configuration mode, specify the T3 controller in slot 0, port 1.
host1(config)# controller t3 0/1
2.
Assign a range of timeslots to a channel and subchannel.
For example, assign the following range of timeslots: 1, 3–8, and 10 to channel
2, subchannel 1. Timeslots 2, 9, and 11–24 are available for other subchannels.
host1(config-controll)# t1 2/1 timeslots 1,3-8,10
Optional Tasks
The T1 channel configuration commands enable you to specify options for a single
channel, multiple individual channels, ranges of channels, or any combination of the
three types of specifications. For example:
host1(config-controll)# t1 2,4,6-15,20-25 clock source line
The following configuration tasks are optional when you configure T1 channels:
14 ■
Configuration Tasks
JUNOSe 10.0.x Physical Layer Configuration Guide