Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 164 / 262

■
Use to specify that T1 channels are used in the carrier environment.
■
Example
host1(config-controll)# path 2 ds3 1 t1 4,6,10-14 fdl carrier
■
Use the no version to restore the default situation, in which the T1 channel does
not operate in the carrier environment.
■
See path ds3 t1 fdl carrier.
path ds3 t1 fdl string
■
Use to configure an FDL message as defined in the ANSI T1.403 specification.
NOTE: The router sends these FDL messages only if you have issued the path ds3
t1 fdl command with the ansi or all keyword and then issued the path ds3 t1 fdl
transmit command.
■
Example
host1(config-controll)# path 2 ds3 1 t1 28 fdl string eic "ERX-1440",
■
Use the no version to restore the default value to the specified FDL message or
to all FDL messages.
■
See path ds3 t1 fdl string.
path ds3 t1 fdl transmit
■
Use to configure the router to send the specified type of FDL message.
■
By default, the router sends only FDL performance data messages.
NOTE: The router sends FDL messages specified with the path ds3 t1 fdl string
command only if you have issued the path ds3 t1 fdl command with the ansi or all
keyword. If you specified the att keyword with the path ds3 t1 fdl command, the
router sends only performance data.
■
Specify the keyword path-id to transmit path identifications every second.
■
Specify the keyword idle-signal to send idle signals every second.
■
Specify the keyword test-signal to transmit test signals every second.
■
Example
host1(config-controll)# path 2 ds3 1 t1 28 fdl transmit path-id
■
Use the no version to disable transmission of the specified FDL message or all
FDL messages.
■
See path ds3 t1 fdl transmit.
138 ■
Configuration Tasks
JUNOSe 10.0.x Physical Layer Configuration Guide