Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 166 / 262

■
Specify one of the following idle characters:
■
flags —Sets the idle character to 0x7E
■
marks —Sets the idle character to 0xFF
■
Example
host1(config-ifs)# idle-character marks
■
Use the no version to restore the default value, 0x7E (flags).
■
See idle-character.
interface serial
■
Use to specify a serial interface.
■
Example for unframed E1 interface
host1(config)# interface serial 4/0:1/1/1/1/1
■
Example for fractional T1/E1 interface
host1(config)# interface serial 4/0:1/1/1/1/1
■
Example for unchannelized T3 interface
host1(config)# interface serial 4/0:1/1
■
Example for T3 interface channelized to fractional T1
host1(config)# interface serial 4/0:1/1/10/22
■
Use the no version to remove the interface.
■
See interface serial.
invert data
■
Use to enable data stream inversion for the interface.
■
Enable data stream inversion only if it is turned on at the other end of the line.
■
Example
host1(config-if)# invert data
■
Use the no version to disable the feature.
■
See invert data.
mru
■
Use to configure the MRU size for the interface.
■
Specify a value in the range 4–9996 bytes.
140 ■
Configuration Tasks
JUNOSe 10.0.x Physical Layer Configuration Guide