Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 158 / 262

■
Use the no version to restore the default value, line .
■
See path ds3 clock source.
path ds3 description
■
Use to assign a text description or an alias to a T3 (DS3) over channelized
SONET/SDH interface.
■
You can use this command to help you identify the interface and keep track of
interface connections.
■
The description or alias can be a maximum of 80 characters.
■
Use “show controllers sonet ds3” on page 161 to display the text description.
■
Example
host1(config-controller)# path 12 ds3 1 description boston_t3
■
Use the no version to remove the text description or alias.
■
See path ds3 description.
path ds3 framing
■
Use to configure the framing format for a T3 interface.
■
Specify c-bit parity framing or m23 multiplexer framing.
■
Example
host1(config-controll)# path 12 ds3 1 framing m23
■
Use the no version to restore the default value, c-bit parity framing.
■
See path ds3 framing.
path ds3 shutdown
■
Use to disable a T3 interface.
■
T3 interfaces are enabled by default.
■
Example
host1(config-controll)# path 12 ds3 1 shutdown
■
Use the no version to restart a disabled interface.
■
See path ds3 shutdown.
path ds3 snmp trap link-status
■
Use to enable SNMP link status processing for a T3 interface.
■
The default disables SNMP link status processing.
■
Example
host1(config-controll)# path 12 ds3 1 snmp trap link-status
132 ■
Configuration Tasks
JUNOSe 10.0.x Physical Layer Configuration Guide