Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 152 / 262

■
Use “show controllers sonet ds1|e1” on page 159 to display the text description.
■
Example
host1(config-controller)# path 10 e1 1/5/1 channel-group 4
description westford e1 151.4
■
Use the no version to remove the text description or alias.
■
See path ds1|e1 channel-group description.
path ds1|e1 channel-group shutdown
■
Use to disable a T1 or an E1 channel group.
■
T1 and E1 channel groups are enabled by default.
■
Example
host1 (config-controll)# path 12 e1 1/4/1 channel-group 2 shutdown
■
Use the no version to restart a disabled channel group.
■
See path ds1|e1 channel-group shutdown.
path ds1|e1 channel-group snmp trap link-status
■
Use to enable SNMP link status processing for a T1 or an E1 channel group.
■
The default is disabled.
■
Example
host1(config-controll)# path 2 ds1 1/1/1 channel-group 2 snmp trap link-status
■
Use the no version to disable SNMP link status processing for a T1 or an E1
channel group.
■
See path ds1|e1 channel-group snmp trap link-status.
path ds1|e1 channel-group timeslots
■
Use to configure T1 or E1 line parameters.
■
You cannot configure a mixture of T1 and E1 lines on the same cOCx/STMx line
module.
■
Specify a T1 or E1 channel group number, and assign a range of timeslots.
■
To configure a whole T1 or E1 line, assign all the timeslots to the channel group.
■
You can specify a line speed that applies to all DS0 timeslots assigned to a channel
group.
■
Example
host1(config-controll)# path 2 ds1 1/1/1 channel-group 2 timeslots 5-6
■
Use the no version to remove the timeslots from the channel group.
■
See path ds1|e1 channel-group timeslots.
126 ■
Configuration Tasks
JUNOSe 10.0.x Physical Layer Configuration Guide