Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 125 / 262

host1# baseline path interface sonet 2/0
■
Example 2—Sets a baseline for SONET path layer interfaces on the E320 router
host1# baseline path interface sonet 3/0/0
■
There is no no version.
■
See baseline path interface sonet.
baseline section interface sonet
■
Use to set a statistics baseline for the SONET/SDH section layer.
■
The router implements the baseline by reading and storing the MIB statistics at
the time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
■
Use the total [ delta ] keywords with the show controllers sonet section
commands to view the baseline statistics.
■
Example 1—Sets a baseline for SONET section layer interfaces on ERX-14xx
models, ERX-7xx models, or the ERX-310 router
host1# baseline section interface sonet 2/0
■
Example 2—Sets a baseline for SONET section layer interfaces on the E320
router
host1# baseline section interface sonet 3/0/0
■
There is no no version.
■
See baseline section interface sonet.
show controllers sonet
■
Use to display the configuration for SONET and SDH interfaces.
■
Field descriptions
■
Interface specifier in slot/port format (ERX-14xx models, ERX-7xx models,
and the ERX-310 router) or slot/adapter/port format (E120 and E320 routers)
■
non channelized—Unchannelized path
■
channelized—Number of channels and speed for the interface
■
ifAdminStatus—Configured status of the interface: up or down
■
description—Configured description of the controller
■
snmp trap link-status—State of SNMP link-status processing for the section
and line layers of the interface: enabled or disabled
■
alarms used for operational status calculation—Types of defects that the
router uses to determine the operational status of the interface at the section
and line layers
Monitoring SONET/SDH Interfaces
■ 99
Chapter 3: Configuring Unchannelized OCx/STMx Interfaces