Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 65 / 262

■
Field descriptions for a T3 interface
■
Far End MDL Carrier bit—Status of MDL configuration on remote device
connected to T3 interface
■
set—MDL is configured for carrier mode
■
not set—MDL is not configured for carrier mode
■
Far End Equipment Identification Code—eic string sent by remote device
for MDL
■
Far End Line Identification Code—lic string sent by remote device for MDL
■
Far End Frame Identification Code—fic string sent by remote device for MDL
■
Far End Unit Identification Code—unit string sent by remote device for MDL
■
Far End Facility Identification Code—pfi string sent by remote device for
MDL
■
Far End Generator Number—generator string sent by remote device for MDL
■
Far End Port Number—port string sent by remote device for MDL
■
Number of valid intervals—Number of 15-minute intervals since the line
module was last powered on or reset
■
Time elapse in current interval—Number of seconds that have passed in the
15-minute (900-second) interval
■
C-bit errored seconds—Number of C-bit errored seconds encountered by a
T3 in the current interval
■
C-bit severely errored seconds—Number of C-bit severely errored seconds
encountered by a T3 in the current interval
■
C-bit coding violations—Number of C-bit coding violations encountered by
a T3 in the current interval
■
Unavailable seconds—Number of unavailable seconds encountered by a T3
in the current interval
■
Invalid seconds—Number of seconds when statistics were not collected
■
Example—In this example, a T3 interface is specified.
host1# show controllers t3 5/0 remote
Far End MDL Carrier bit is not set
Far End Equipment Identification Code is the null string
Far End Line Identification Code is the null string
Far End Frame Identification Code is the null string
Far End Unit Identification Code is the null string
Far End Facility Identification Code is the null string
Far End Generator Number is the null string
Far End Port Number is the null string
Monitoring Interfaces
■ 39
Chapter 1: Configuring Channelized T3 Interfaces