Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 235 / 262

Link: Operational Secondary Link Selected,
Administrative Link Selected Automatically
Link Failover Timeout: Operational 652 ms, Administrative default
Primary link selected 6302 times, Secondary link selected 6302 times
Primary link signal detected, Secondary link signal detected
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
In: Bytes 0, Unicast 0
Multicast 0, Broadcast 0
Errors 0, Discards 0, Mac Errors 0, Alignment 0
CRC 0, Too Longs 0, Symbol Errors 0
Out: Bytes 0, Unicast 0
Multicast 0, Broadcast 0
Errors 0, Discards 0, Mac Errors 0, Deferred 0, No Carrier 0
Collisions: Single 0, Multiple 0, Late 0, Excessive 0
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Administrative qos-shaping-mode: none
Operational qos-shaping-mode: none
queue 0: traffic class control, bound to GigabitEthernet10/2
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
■
See show interfaces.
show ip mac-validate interface
■
Use to display the status of the MAC address validation on the physical interface.
■
Field descriptions
■
FastEthernet interfaceSpecifier —On the ERX-14xx models, ERX-7xx models,
and ERX-310 router, the Fast Ethernet or Gigabit Ethernet interface slot/port ;
on the E120 and E320 routers, the Gigabit Ethernet or 10-Gigabit Ethernet
interface
slot/adapter/port
■
Keyword assigned to interface—Options: Strict or Loose
■
Address—IP address of the entry
■
Hardware Addr—Physical (MAC) address of the entry
■
Example
host1:boston# show ip mac-validate interface fastEthernet 11/0
FastEthernet11/0: Strict
Monitoring Ethernet Interfaces
■ 209
Chapter 5: Configuring Ethernet Interfaces