Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 78 / 262

■
slot —Number of the slot in which the line module resides in the chassis
■
port —Number of the port on the I/O module
■
Example
host1(config)# controller e3 3/2
■
There is no no version.
■
See controller e3.
controller t3
Use to specify a T3 controller in slot/port format.
■
■
slot —Number of the slot in which the line module resides in the chassis
■
port —Number of the port on the I/O module
■
Example
host1(config)# controller t3 0/1
■
There is no no version.
■
See controller t3.
shutdown
■
Use to disable a T3 or an E3 controller.
■
The T3 or E3 interface is disabled by default.
■
Example
host1(config-controll)# shutdown
■
Use the no version to restart a disabled interface.
■
See shutdown.
Configuring MDL Messages
You can configure a T3 interface to send MDL messages. MDL messages are supported
only when T3 framing uses C-bit parity, the default setting.
To configure a T3 interface to send MDL messages:
1.
Specify a T3 interface.
host1(config)# controller t3 8/0
2.
(Optional) Configure the interface to operate in an MDL carrier environment.
host1(config-controll)# mdl carrier
52 ■
Configuration Tasks
JUNOSe 10.0.x Physical Layer Configuration Guide