Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 85 / 262

■
Example
host1(config-if)# invert data
■
Use the no version to disable the feature.
■
See invert data.
load-interval
■
Use to set the time interval at which the router calculates bit and packet rate
counters.
■
Choose a multiple of 30 seconds, in the range 30–300 seconds.
■
Example
host1(config-if)# load-interval 90
■
Use the no version to restore the default value, 300 seconds.
■
See load-interval.
mru
■
Use to configure the MRU size for the interface.
■
Specify a value in the range 4–9996 bytes.
■
Coordinate this value with the network administrator on the other end of the
line.
■
If you set this parameter to a different value for another protocol, such as IP, the
router uses the lower value. This could produce unexpected behavior in your
network.
■
Example
host1(config-if)# mru 1500
■
Use the no version to restore the default, 1600 bytes.
■
See mru.
mtu
■
Use to configure the MTU size for the interface.
■
Specify a value in the range 4–9996 bytes.
■
Coordinate this value with the network administrator on the other end of the
line.
■
If you set this parameter to a different value for another protocol, such as IP, the
router uses the lower value. This could produce unexpected behavior in your
network.
■
Example
host1(config-if)# mtu 1500
Configuration Tasks
■ 59
Chapter 2: Configuring T3 and E3 Interfaces