Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 57 / 262

■
snmp trap link-status —S tatus of SNMP trapping (enabled or disabled)
■
alarms detected—One of the following T3 alarms:
■
No alarm present—No alarms present on the line
■
Rcv RAI Failure—Remote device is sending a far end alarm failure
■
Xmt RAI Failure—Local device is sending a far end alarm failure
■
Rcv AIS—Remote device is sending an alarm indication signal (AIS)
■
Xmt AIS—Local device is sending an AIS
■
Rcv LOF—Loss of one or more frames from the remote end
■
Rcv LOS—Loss of signal at the local end
■
Undefined line status—Indicates that the line is in an undefined state
NOTE: The alarms detected field does not appear for interfaces that you disabled in
the software.
■
framing—Type of framing format
■
line code—Type of line code format
■
clock source—Type of clock source
■
cable length—Cable length, in feet
■
Loopback—State of loopback for the controller: enabled or disabled. If
loopback is enabled, one of the following states is displayed:
■
Diagnostic—Loops the data back toward the router and sends an AIS
toward the network
■
Payload—Loops the data toward the network after the framer has
processed the data
■
Line—Loops the data toward the network before the data reaches the
framer
■
MDL Transmit Path—Status of path transmission: active or not active
■
MDL Transmit Test-Signal—Status of test signal: active or not active
■
MDL Transmit Idle-Signal—Status of idle signal: active or not active
■
Equipment Identification Code—eic string for MDL
■
Line Identification Code—lic string for MDL
■
Frame Identification Code—fic string for MDL
■
Unit Identification Code—unit string for MDL
Monitoring Interfaces
■ 31
Chapter 1: Configuring Channelized T3 Interfaces