Juniper JUNOSE 10.0.X PHYSICAL LAYER, Configuration Manual

Page: 62 / 262

■
Degraded minutes—Number of minutes that a T1 line is degraded
■
Line code violations—Number of line code violations encountered by a T1
in the current interval
■
Example 1—In this example, a T1 channel and the brief keyword are specified.
host1# show controllers t1 2/0:1 brief
DS3 2/0:1
ifOperStatus = ifOperUp
Yellow Alarm detection is active
Yellow Alarm generation is active
snmp trap link-status = disabled
Framing is D4, Line Code is Ami, Clock Source is Internal - Module
Allocated Ds0 time slot map = 0x0
Loopback Enabled - Diagnostic
Last Remote Loopback Request Sent - Deactivate
FDL is not configured
FDL Transmit Path-Id is not active
FDL Transmit Test-Signal is not active
FDL Transmit Idle-Signal is not active
Equipment Identification Code is the null string
Line Identification Code is the null string
Frame Identification Code is the null string
Unit Identification Code is the null string
Facility Identification Code is the null string
Port Code is the null string
Generator Number is the null string
BERT test - 2 in 23
Test Interval 1 minute(s), Complete
Sync count = 1
Received bit count = 92148912
Error bit count = 17
Number of valid interval - 90
Time elapse in current interval - 580
■
Example 2—In this example, the brief keyword is specified for all T1 channels.
host1# show controllers t1 brief
Interfaces ifAdminStatus OperationalStatus
5/0:1(framed) up lowerLayerDown
5/0:2(framed) up lowerLayerDown
5/0:3(framed) up lowerLayerDown
5/0:4(framed) up lowerLayerDown
5/0:5(framed) up lowerLayerDown
5/0:6(framed) up lowerLayerDown
...
5/2:26(framed) up lowerLayerDown
5/2:27(framed) up lowerLayerDown
5/2:28(framed) up lowerLayerDown
■
Example 3—In this example, a T1 channel is specified.
host1# show controllers t1 1/0:1
36 ■
Monitoring Interfaces
JUNOSe 10.0.x Physical Layer Configuration Guide