Juniper J4350, Getting Started Manual

Page: 190 / 284

J4350 and J6350 Services Router Getting Started Guide
5.
Push the Crypto Module down flat against the main board until the release
clips click into place, as shown in Figure 53.
6.
Insert the standoff washer under the Crypto Module.
7.
Insert the screw and tighten it until snug. Do not overtighten.
8.
Slide the cover onto the router, and replace and tighten the cover screws.
9.
Replace the power cord or cable.
10.
Press and release the power button to power on the router. Verify that the
POWER
LED lights steadily after you press the power button.
11.
Verify that the Crypto Module is correctly installed by issuing the
show chassis
hardware
command, as shown in the following example:
user@host> show chassis hardware
Hardware inventory:
Item Version Part number Serial number Description
Chassis JN1086A34ADA J4350
Midplane REV 00 710-014594
System IO REV 00 710-012315 JX350 System IO
Routing Engine REV 00 710-012149 RE-J4350-2540
Crypto Module Crypto acceleration
FPC 0 FPC
PIC 0 4x GE Base PIC
If
Crypto Module
appears in the output, the Crypto Accelerator Module is
installed correctly.
Replacing an Air Filter
The front panel of J4350 and J6350 Services Routers contains an air intake
grid with a protective cover and a filter, as shown in Figure 54.
170
Replacing Hardware Components