Juniper J4350, Getting Started Manual

Page: 107 / 284

Installing and Connecting a Services Router
For power cord requirements, see “AC Power, Connection, and Power
Cord Specifications” on page 76
To connect AC power to the router:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strip to the ESD point on the chassis. For more information about
ESD, see “Preventing Electrostatic Discharge Damage” on page 205.
2.
Use a grounding cable to connect the router to earth ground: (For cable
requirements, see “Chassis Grounding” on page 86.)
a.
Verify that a licensed electrician has attached an appropriate grounding
cable lug to the grounding cable.
b.
Connect one end of the grounding cable to a proper earth ground, such as
the rack in which the router is installed.
c.
With a Phillips screwdriver, remove the screws and washers from the PEM
nuts at the grounding point on the rear of the chassis.
d.
Place the grounding lug at the other end of the cable over the grounding
point, as shown in Figure 33.
e.
Secure the cable lug to the grounding point, first with the washers, then
with the screws.
3.
Locate the power cord or cords shipped with the router, which has a plug
appropriate for your geographical location. For power cord specifications, see
“Power Guidelines, Requirements, and Specifications” on page 74.
4.
For each power supply:
a.
Insert the appliance coupler end of a power cord into the appliance inlet on
the power supply faceplate, as shown in Figure 33.
b.
Insert the plug into an AC power source receptacle.
5.
Verify that the power cord does not block access to router components or
drape where people can trip on it.
Connecting Power
87