Art. No. DS 4092 TS
Figure 37: Example to change the value for dimming value transmitter
i
There is no value over- or underrun on adjustment. If, during an adjustment, the maximum
or minimum value is reached, no more telegrams are transmitted.
i
To ensure that, during a value adjustment, for example the controlled lighting switches off
or switches on at the maximum, the limit values (e.g. the values "0" or "255") are always
transmitted when the limits of the adjustable range are reached. This also takes place
when the configured step width of these values is not immediately taken into account (see
example above: step width = 5; value "2" is transmitted, then value "0").
In this case, to ensure that the original starting value can be reset on resetting with a
change to the adjustment direction, the first value jump is not equal to the preset step width
(see example above: step width = 5; value "0" is transmitted, then values "2"; "7" etc.).
i
The newly adjusted values are stored in RAM. After a device reset (bus voltage failure or
ETS programming operation), the adjusted values are replaced by the values originally
configured in the ETS.
Light scene extension
With a configuration as a light scene extension without a memory function, it is possible to recall
a light scene, which is stored in an external bus subscriber (e.g. light scene pushbutton sensor)
With a rising, falling or rising and falling edge, the light scene number configured in the ETS is
immediately transmitted to the bus.
With a configuration as a light scene extension with a memory function, it is possible to generate
a memory telegram according to the light scene to be transmitted. For this, the appropriate
memory telegram is transmitted for a long signal according to the configured edge evaluation
(pushbutton as NC contact or NO contact - not as switch!). In this case, the time for long
actuation can be configured (but not to below 5 s). With short actuation < 1 s, the configured
light scene number (without memory telegram) is transmitted. If the actuation last longer than
1 s but less than 5 s, no telegram is triggered.
In addition, there is the option of only transmitting a memory telegram without prior light scene
recall. In this case, the parameter "Only memory function ?" must be set to "Yes".
Examples for a light scene extension with memory function (figure 38):
1.) Only memory function = No
2.) Only memory function = Yes
Page 83 of 143
Software "Rotary sensor with extensions 10FE1x"
Functional description
