Art. No. DS 4092 TS
Value on falling edge
0 Lux
...1,500 Lux
This parameter specifies the brightness
value transmitted on a falling edge.
Only visible with "Brightness value
transmitter" and "Transmit value on =
falling edge (pushbutton as NC contact)"
and "Transmit value on = rising and
falling edge (switch)".
Behaviour after bus
voltage
return
After a device reset (bus voltage return
or ETS programming operation), the
communication object of the value
transmitter or light scene extension can
be initialised. If, in the ETS, a delay is
set for the extension inputs after bus
voltage return, the device only transmits
the telegrams when the delay has
elapsed.
No reaction
After a device reset, no reaction takes
place automatically (no telegram is
transmitted to the bus).
Reaction as rising edge
In this configuration, a telegram is
actively transmitted to the bus after a
device reset in accordance with the
configuration for the rising edge.
Reaction as falling edge
In this configuration, a telegram is
actively transmitted to the bus after a
device reset in accordance with the
configuration for the falling edge.
Transmit current input
status
In this setting, the device evaluates the
static signal status of the input and,
according to this, transmits the
appropriately configured telegram to the
bus (contact closed at the input =
telegram as with rising edge; contact
open at input = telegram as with falling
edge).
This setting can only be configured with
"Transmit value on = rising and falling
edge (switch)".
Adjustment via long
actuation
no
yes
With the dimming value transmitter and
the temperature and brightness value
transmitter, the value to be transmitted
can be adjusted at any time during
device operation. A value adjustment
can only be configurable here when the
value is to be transmitted only on a
rising edge or only on a falling edge, i.e.
a pushbutton is connected to the input.
A value adjustment is introduced by a
long signal at the input (> 5 s) and
continues for as long as the signal is
detected as active, i.e. the pushbutton is
actuated.
With the first adjustment after
commissioning, the value programmed
by the ETS is increased cyclically by the
Page 133 of 143
Software "Rotary sensor with extensions 10FE1x"
Parameters
