Art. No. DS 4092 TS
step width configured for the dimming
value transmitter and transmitted. The
step width of the temperature value
transmitter (1 °C) and the brightness
value transmitter (50 Lux) is
permanently defined. The previously
transmitted value is saved after
releasing the pushbutton. The next long
pushbutton actuation adjusts the saved
value and the direction of the value
adjustment changes.
Only visible with "Transmit value on =
rising edge (pushbutton as NO contact)"
and "Transmit value on = falling edge
(pushbutton as NC contact)".
Time between two
telegrams
Seconds (0...59)
0...
1
...59
The time between two telegrams on
adjusting values can be configured here.
Only visible on "Adjustment via long
actuation = yes"!
Sets the time seconds.
Milliseconds (5...9 x
100)
5
...9
Sets the time milliseconds.
Step width (1...10)
1...
10
Step width by which the adjusted value
is increased or decreased with long
actuation.
Only visible on "Function as = Dimming
value transmitter".
h
Ex - disable (X = 1, 2, 3) - Only for "Switching" function!
Disabling function
switching object 1.1
disabled
enabled
The extension inputs can be separately
disabled via the bus using 1-bit objects.
With the "Switching" function, it is
possible to disable the two switching
objects of an input independently of
each other. With an active disabling
function, signal edges at the input are
ignored by the device related to the
affected objects.
This parameter enables the disabling
function of the first communication
object.
Polarity of the disabling
object
disable = 1 /
enable = 0
disable = 0 /
enable = 1
This parameter defines the polarity of
the disabling object.
Behaviour at the
beginning of the
No reaction
ON
With an active disable, the first switching
object is disabled. This parameter
specifies the command transmitted via
Page 134 of 143
Software "Rotary sensor with extensions 10FE1x"
Parameters
