Art. No. DS 4092 TS
command
(1...3,000 x 100 ms)
This parameter is not visible with
"Operation concept = long – short"!
Slat adjusting time
(0...3,000 x 100 ms)
0 …
5
… 3000
During the slat adjustment time, a
transmitted MOVE telegram can be
terminated by releasing the button
(STEP). This function serves to adjust
the slats of a blind.
This parameter is not visible with
"Operation concept = long – short"!
The following parameters are visible for the function "Value transmitter 1 byte"...
Function
Value transmitter 0...255
Value transmitter 0…100 %
If the push-button is configured as
"1-byte value transmitter", values can be
transmitted as integers from 0 to 255 or
as a percentage from 0 % to 100 %
during a button-press. The following
parameters and their settings depend on
this distinction.
Value (0...255)
0
...255
This parameter defines the object value
when the button is pressed.
Visible only if "Function = 0...255"!
Value (0...100 %)
0
...100
This parameter defines the object value
when the button is pressed.
Visible only if "Function = 0...100 %"!
Value adjustment by
long button-press
disabled
enabled
If value adjustment by long button-press
is enabled, the ETS shows further
parameters.
Value adjustment begins, when the
button is held down for more than 5 s.
Starting value in case of
value adjustment
Value adjustment can begin with
different starting values.
same as configured value
After each long press, the device always
starts with the value configured in the
ETS.
same as value after last
adjustment
After a long press, the device starts with
the value transmitted by itself as the last
value.
same as value from
communication object
After a long press, the device starts with
the value transmitted by itself or by
another device with this group address
as the last value.
This parameter is only visible if "Value
adjustment by long button-press =
enabled"!
Page 101 of 143
Software "Rotary sensor with extensions 10FE1x"
Parameters
