Art. No. DS 4092 TS
45 notches)
720° (2 times rotation,
60 notches)
configured if the control speed is
normally faster or the slat travelling time
long.
If drives for rolling shutters, awnings or
windows are activated by the rotary
knob function "Venetian blind", i.e. slat
control is unnecessary, the rotation
angle for the slat adjustment should be
set to the smallest angle (45°).
Time for standstill after
each operation
300ms
500 ms
1 sec
2 sec
The device differentiates between
different operations based upon the time
that the rotary knob stands still after a
completed operation. This standstill time
is configured here and should not be
selected too short in order to avoid
unintended switching operations -
particularly during fast operations. If the
device detects additional operations
immediately after a rotary movement
(time not yet elapsed), it then ignores
the continuing movement of the rotary
knob. The time for standstill detection is
retriggered for each rotary knob
movement.
The following parameters are visible for the function "Value transmitter 1 byte"...
Function
The rotary knob function "1-byte value
transmitter" distinguishes three different
functions.
Value transmitter 0...255
In this function, the rotary knob transmits
unformatted values within a range of
"0...255" according to the KNX data type
5.010. Such values are normally used
for presettings for counter statuses or
limiting values. Optionally, a value
adjustment can be carried out by
adjusting the rotary knob by a defined
rotation angle.
Value transmitter 0…100 % In this function, the rotary knob transmits
formatted values within a range of
"0...100%" according to the KNX data
type 5.001. Such a value formatting in
percentage is normally used for
brightness value or position presettings.
Optionally, a value adjustment can be
carried out by adjusting the rotary knob
by a defined rotation angle.
Value transmitter comfort
0...255
This function supports the operation of
the rotary knob for transmitting values
dependent on speed and rotation angle.
Here, depending on the speed of
rotation, a value adjustment is possible
by small and large step widths, thereby
allowing the brightness of a lighting
system to be set finely and gradually.
Page 112 of 143
Software "Rotary sensor with extensions 10FE1x"
Parameters
