Art. No. DS 4092 TS
Time for standstill after
each operation
300ms
500 ms
1 sec
2 sec
The device differentiates between
different operations based upon the time
that the rotary knob stands still after a
completed operation. This standstill time
is configured here and should not be
selected too short in order to avoid
unintended switching operations -
particularly during fast operations. If the
device detects additional operations
immediately after a rotary movement
(time not yet elapsed), it then ignores
the continuing movement of the rotary
knob. The time for standstill detection is
retriggered for each rotary knob
movement.
The following parameters are visible for the function "Value transmitter 2 byte"...
Function
The rotary knob function "2-byte value
transmitter" distinguishes three different
functions.
Temperature value
transmitter
In this function, the rotary knob transmits
formatted 2-byte temperature values
within a range of "0...+40°C" according
to the KNX data type 9.001. Such values
are normally used for basic setpoint
temperatures for room temperature
controllers. Optionally, a value
adjustment can be carried out by
adjusting the rotary knob by a defined
rotation angle.
Brightness value
transmitter
In this function, the rotary knob transmits
formatted 2-byte temperature values
within a range of "0...1500 lux"
according to the KNX data type 9.004.
Such values are normally used for
brightness setpoint presettings for
constant light regulations. Optionally, a
value adjustment can be carried out by
adjusting the rotary knob by a defined
rotation angle.
Value transmitter 0...65535 In this function, the device is able to
transmit unformatted 2-byte values
within a range "0...65535" to the bus
according to the KNX data type 7.001.
Such values are normally used for the
presetting for counter limiting values.
Optionally, a value adjustment can be
carried out by adjusting the rotary knob
by a defined rotation angle.
Function Value
adjustment
disabled
enabled
This parameter distinguishes whether
just a value recall takes place and
whether a value adjustment is also
possible.
Page 116 of 143
Software "Rotary sensor with extensions 10FE1x"
Parameters
