Art. No. DS 4092 TS
operation concepts "Dimming comfort
without OFF telegram" and "Dimming
comfort with OFF telegram".
Time for standstill after
each operation
300ms
500 ms
1 sec
2 sec
The device differentiates between
different operations based upon the time
that the rotary knob stands still after a
completed operation. This standstill time
is configured here and should not be
selected too short in order to avoid
unintended switching operations -
particularly during fast operations. If the
device detects additional operations
immediately after a rotary movement
(time not yet elapsed), it then ignores
the continuing movement of the rotary
knob. The time for standstill detection is
retriggered for each rotary knob
movement.
The following parameters are visible for the function "Venetian Blind"...
Operation concept
Move-Step
The rotary knob supports the operation
concept "Move - Step" in the blind
function. Here, the rotation angle of the
rotary knob (number of notches during a
rotary movement) is evaluated during an
operation in order to distinguish between
an operation for the blind/shutter
movement (MOVE, UP, DOWN) or slat
adjustment (MOVE -> STEP).
Command on turning /
rotation direction
Clockwise: DOWN /
anticlockwise: UP
Clockwise: UP /
anticlockwise: DOWN
This parameter determines the
movement direction command (raise /
open slats, lower / close slats) for the
operating direction of the rotary knob
movement (clockwise or anticlockwise).
Maximum rotation angle
for slat adjustment
45° (approx. 1/8 rotation,
4 notches)
90° (approx. 1/4 rotation,
7 notches)
180° (approx. 1/2 rotation,
15 notches)
270° (approx. 3/4 rotation,
22 notches)
360° (complete rotation,
30 notches)
540° (1.5 times rotation,
If the rotary knob stops during an
operation within the rotation angle
preset here for a slat adjustment, the
device immediately transmits a short
time telegram (STEP). This function is
used for adjusting the slats of a blind.
This allows slats to be stopped at any
position during their rotation.
The parameter "Maximum rotation angle
for slat adjustment" must be set to the
expected control speed of the rotary
knob and to the slat travelling time.
Small angles should normally be
selected if the operation is slow or the
slat travelling time is short. Likewise,
large angles of rotation are to be
Page 111 of 143
Software "Rotary sensor with extensions 10FE1x"
Parameters
