– 81 –
No.
Name
Selection item
Setting
range
Unit &
Meaning
Initial value
HS3020RSZ
GS3020RSZ
HS3020RSW
GS3020RSW
U040 With/without origin retrieval at the end
of sewing (in the case of cycle sewing)
0: Without origin retrieval
1: With origin retrieval (on a pat-
tern-by-pattern basis)
2: With origin retrieval (after the end
of each cycle)
0 to 2
-
0
U041 Selection of lift of the feeding frame by
the temporary stop command
0: Feeding frame goes up
1: Feeding frame goes up with the
feeding frame switch
0 to 1
-
0
U042 Selection of the needle stop position
0: Upper position
1: Upper dead point position
0 to 1
-
0
U046 Selection of prohibition of the thread
trimming command control
0: Enable
1: Disable
0 to 1
-
0
U048 Selection of return-to-origin at the time
or return-to-origin operation
0: Straight-line return
1: Reverse-tracing of pattern data
2: Origin retrieval
→
Sewing start
point
0 to 2
-
0
U049 Selection of bobbin winding speed
800 to
2,000
100
sti/min
1,600
U050 Setting of the length of thread remain-
ing at the end of sewing
0: Standard
1: Long
2: Longer
0 to 2
-
0
U051 Selection of enable / disable of wiper
operation
0: Disable
1: Enable
0 to 1
-
1
U055 Minimum jump distance to carry out
thread trimming
0 to 12.8
mm
0.1 mm
0
U064 Method to set the XY enlargement /
reduction ratio
0: Set in %
1: Set with actual dimension
0 to 1
-
0
U068 Thread tension output time during
setting of the thread tension value
0 to 20
1 stitch
20
U069 Selection of bending position of thread
clamp
0: S type
1: H type (thin thread)
2: H type (Medium)
3: H type (Thick thread)
0 to 3
-
0
