Fig. 138: CONNECTING ROD TO CYLINDER IDENTIFICATION
Courtesy of CHRYSLER LLC
1. Remove the engine assembly. See
Engine - Removal
.
2. Mount engine on an engine stand.
3. Remove the oil filter.
4. Remove the oil pan and oil pick-up tube. See
Engine/Lubrication/PAN, Oil - Removal
.
5. Remove the timing chain cover. See
Engine/Valve Timing/COVER(S), Engine Timing - Removal
.
6. Remove timing chain and sprockets. Refer to
CHAIN and SPROCKETS, Timing
.
7. Remove crankshaft rear oil seal and retainer. See
Engine/Engine Block/RETAINER, Crankshaft Rear
Oil Seal - Removal
.
8. Rotate the crankshaft until connecting rod cap is accessible.
9. Paint mark or scribe the connecting rod cap position (1).
10. Remove connecting rod bearing cap. Use care to prevent damage to the crankshaft bearing surfaces.
11. Repeat removal procedure for each connecting rod cap.
1 - PAINT MARK OR SCRIBE
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
viernes, 1 de octubre de 2021 05:18:31 p. m.
Page 108
© 2011 Mitchell Repair Information Company, LLC.
