6. Install and tighten the NEW cross bolts and washer assemblies (8) to 61 N.m (45 ft. lbs.).
7. Position and install the connecting rod and bearing caps on the crankshaft. See
Engine/Engine
Block/BEARING(S), Connecting Rod - Standard Procedure
.
8. Install the crankshaft rear oil seal. See
Engine/Engine Block/RETAINER, Crankshaft Rear Oil Seal -
Installation
.
9. Install the crankshaft sprocket. Refer to
CHAIN and SPROCKETS, Timing
.
10. Install the timing chain and camshaft sprocket. Refer to
CHAIN and SPROCKETS, Timing
.
11. Install the timing chain cover. See
Engine/Valve Timing/COVER(S), Engine Timing - Installation
.
12. Install the oil pick-up tube and oil pan. See
Engine/Lubrication/PAN, Oil - Installation
.
13. Install the engine assembly. See
Engine - Installation
.
DAMPER, VIBRATION
Removal
REMOVAL
Fig. 143: VIBRATION DAMPER - REMOVAL
Courtesy of CHRYSLER LLC
1. Disconnect and isolate the negative battery cable.
2. Raise and secure vehicle on hoist. Refer to
Vehicle Quick Reference/Hoisting - Standard Procedure
.
3. Remove the accessory drive belt. Refer to
Cooling/Accessory Drive/BELT, Serpentine - Removal
.
4. Remove vibration damper bolt.
5. Place Crankshaft Insert 8450 (2) into crankshaft nose.
6. Position Puller 1023 (1) on damper. Turn puller forcing screw until damper releases from crankshaft.
7. Remove the crankshaft vibration damper.
Installation
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
viernes, 1 de octubre de 2021 05:18:31 p. m.
Page 113
© 2011 Mitchell Repair Information Company, LLC.
