21. Remove the timing chain cover fasteners (1-7) and remove the timing chain cover.
Installation
INSTALLATION
Fig. 254: TIMING COVER BOLT LOCATION
Courtesy of CHRYSLER LLC
1. Be sure the mating surfaces of the chain case cover and cylinder block are clean and free from burrs.
2. Position the new timing cover gasket on the timing cover. Adhere the new gasket to the chain case cover,
making sure that the lower edge of the gasket is 0.5 mm (0.020 in.) beyond the lower edge of the cover.
3. Rotate the crankshaft so that the oil pump drive flats are in the vertical position.
4. Position the oil pump inner rotor so that the mating flats are in the same position as the crankshaft drive
flats.
1,7 - BOLT - M8 x 1.25 x 80
4 - BOLT - M10 x 1.5 x 85
2 - BOLT - M10 x 1.5 x 85
5 - BOLT - M8 x 1.25 x 80
3 - BOLT - M8 x 1.25 x 80
6 - BOLT - M10 x 1.5 x 85
CAUTION: Crankshaft oil seal must be removed to insure correct oil pump
engagement.
NOTE:
DO NOT USE SEALER ON THE TIMING COVER GASKET
CAUTION: Make sure the oil pump is engaged on the crankshaft correctly or
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
viernes, 1 de octubre de 2021 05:18:33 p. m.
Page 203
© 2011 Mitchell Repair Information Company, LLC.
