Fig. 118: CONNECTING ROD TO CYLINDER IDENTIFICATION
Courtesy of CHRYSLER LLC
The bearing caps are not interchangeable and should be marked (1) at removal to ensure correct assembly. The
bearing shells must be installed with the tangs inserted into the machined grooves in the rods and caps. Install
cap with the tangs on the same side as the rod. Fit all rods on one bank until complete. Connecting rod bearings
are available in the standard size and the following undersizes: 0.025 mm (0.001 in.) and 0.250 mm (0.010 in.).
Measure connecting rod journal for taper and out-of-round. See
Engine - Specifications
.
1 - PAINT MARK OR SCRIBE
CAUTION: Install the bearings in pairs. Do not use a new bearing half with an old
bearing half. Do not file the rods or bearing caps.
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
viernes, 1 de octubre de 2021 05:18:31 p. m.
Page 92
© 2011 Mitchell Repair Information Company, LLC.
