Fig. 174: Rear Mount (AutomaticTransmission)
Courtesy of CHRYSLER LLC
1. Position the skid plate to the studs of the support cushion and install the nuts. Tighten the nuts to 28 N.m
(21 ft. lbs.) torque.
2. Install the skid plate bolts to the sill and tighten to 75 N.m (55 ft. lbs.) torque.
3. Remove the transmission support.
4. Lower the vehicle.
5. Connect negative cable to battery.
6. Position the transmission mount bracket to the transmission and install the bolts. Tighten the bolts to 54
N.m (40 ft. lbs.) torque.
7. Position the support cushion (2) to the transmission mount bracket and install nuts. Tighten the nuts to 41
N.m (30 ft. lbs.) torque.
8. If the support cushion bracket was removed from the skid plate, position the bracket on the skid plate and
install the nuts and bolts. Tighten the nuts to 28 N.m (21 ft. lbs.) torque.
LUBRICATION
DESCRIPTION
1 - BRACKET
2 - CUSHION
3 - BRACKET
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
viernes, 1 de octubre de 2021 05:18:31 p. m.
Page 143
© 2011 Mitchell Repair Information Company, LLC.
