9. Start engine and inspect for leaks.
10. Stop engine and inspect oil level.
ENGINE OIL LEVEL CHECK
The best time to check engine oil level is after it has sat overnight, or if the engine has been running, allow the
engine to be shut off for at least 5 minutes before checking oil level.
Checking the oil while the vehicle is on level ground will improve the accuracy of the oil level reading. Add
engine oil only when the level is at or below the ADD mark on the indicator.
PAN, OIL
Removal
REMOVAL
1. Disconnect negative cable from battery and remove engine oil level indicator tube.
2. Remove engine oil level indicator tube.
Fig. 179: 3.8L Oil Pressure Switch
Courtesy of CHRYSLER LLC
3. Raise vehicle on hoist and drain engine oil, and remove the oil filter (2).
NOTE:
Care should be exercised when disposing used engine oil after it has been
drained from a vehicle engine. Refer to the WARNING listed above.
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
viernes, 1 de octubre de 2021 05:18:32 p. m.
Page 148
© 2011 Mitchell Repair Information Company, LLC.
