Fig. 228: SEALER LOCATIONS
Courtesy of CHRYSLER LLC
1. Place a bead (approximately 1/4 in. diameter) of Mopar® Engine RTV GEN II onto each of the
four
manifold to cylinder head gasket corners (1).
2. Carefully install the new intake manifold gasket. Tighten end seal retainer screws to 12 N.m (105 in. lbs.).
Fig. 229: LOWER MANIFOLD TIGHTENING SEQUENCE
Courtesy of CHRYSLER LLC
3. Install lower intake manifold. Install the bolts and torque to 1 N.m (10 in. lbs.). Then torque bolts to 22
N.m (200 in. lbs.) in sequence shown in illustration. Then torque again to 22 N.m (200 in. lbs.). After
intake manifold is in place,
inspect to make sure seals are in place.
1 - SEALER LOCATIONS
2010 Jeep Wrangler Sport
2010 ENGINE 3.8L - Service Information - Wrangler
viernes, 1 de octubre de 2021 05:18:32 p. m.
Page 185
© 2011 Mitchell Repair Information Company, LLC.
