![background image](http://html1.mh-extra.com/html/jcm-global/ivizion-ld/ivizion-ld_operation-and-maintenance-manual_640273050.webp)
P/N 960-100929R_Rev. 3 {EDP #148849}
© 2012, Japan CashMachine Co., Limited
4 - 2
Section 4
iVIZION® Series Next-Generation Banknote Acceptor Unit
Disassembly/Reassembly
6. Remove the two (2) screws (See Figure 4-4 a
1
&
a
2
) retaining the two (2) Flat Leaf Springs
1
& b
2
). Remove the two (2) Flat
Springs, the single (1) Stacker Guide (See Figure
4-4 c), the single (1) Retainer Pin (See Figure 4-4
d), the two (2) Rollers (See Figure 4-4 e
1
& e
2
)
and the two (2) related pressure Coil Springs
(See Figure 4-4 f & Figure 4-5 below) from the
Pusher Mechanism Assembly.
7. Remove the single (1) E-ring (See Figure 4-6 a)
and the single (1) Gear (See Figure 4-6 b) located
on the right side of the Transport Unit.
8. Remove the three (3) Assembly Mounting Screws
1,
e
2
& e
3
) located on the right
side of the Transport Unit, and remove the Right
Frame Outer “R” Assembly (See Figure 4-6 f)
from the Transport Unit.
9. Remove the single (1) E-ring (See Figure 4-7 a)
and the two (2) Gears (See Figure 4-7 b
1
& b
2
)
located on the left side of the Transport Unit.
10. Remove the three (3) Assembly Mounting Screws
1,
e
2
& e
3
) and remove the Left
Frame Outer “L” Assembly (See Figure 4-7 f)
from the Transport Unit.
Figure 4-4
Stacker Guide Removal
a
1
a
2
b
1
b
2
d
c
e
1
e
2
f
NOTE: When reassembling the Stacker
Guide (See Figure 4-5 a), ensure that
each Coil Spring (See Figure 4-5 b)
direction is replaced correctly. When
reinserting the Retaining Pin, put it in place
while lifting the Coil Spring upward; then
put the Screw Locks back onto the Screws
retaining each Coil Spring in place.
Figure 4-5
Stacker Guide Reassembly
a
b
Hidden
NOTE: Be careful that the parallel Pins (See
Figure 4-6 c) and their related Bushings
1
& d
2
) are not lost when
removing them.
Figure 4-6
Right Frame Outer “R” Removal
a
b
c
d
1
e
1
e
2
e
3
g
d
2
f
NOTE: When replacing the Frame Outer
“R” Assembly, ensure that the Plate Nut is
correctly re-positioned (See Figure 4-6 g).
NOTE: Be careful that the parallel Pins (See
Figure 4-7 c) and their related Bushings
1,
d
2
& d
3
) are not lost
when removing them.
Figure 4-7
Left Frame Outer “L” Removal
a
b
2
b
1
c d
1
d
2
e
1
e
2
e
3
f
g
d
3