![background image](http://html1.mh-extra.com/html/jcm-global/ivizion-ld/ivizion-ld_operation-and-maintenance-manual_640273052.webp)
P/N 960-100929R_Rev. 3 {EDP #148849}
© 2012, Japan CashMachine Co., Limited
4 - 4
Section 4
iVIZION® Series Next-Generation Banknote Acceptor Unit
Disassembly/Reassembly
RFID Module & Harness Removals
To remove the RFID Module and RFID Harness
proceed as follows:
1. Remove the two (2) mounting Screws (See Figure
1 &
a
2
) retaining the RFID Module to the
back side of the Transport Unit (See Figure 4-12
b).
2. Remove the RFID Module and the RFID
Harness (See Figure 4-12 c) from the Transport
Unit.
Validation CPU & Controller CPU
Board Removals
To remove the Validation CPU Board and the Con-
troller CPU Board from the CPU Board Module,
proceed as follows:
1. Remove the four (4) mounting Screws that are
1
through
a
4
) retaining the CPU
Board Module (See Figure 4-13 d) to the Trans-
port Unit, and unplug the two (2) Signal Connec-
tors (See Figure 4-13 b
1
& b
2
) with the three (3)
Flat Ribbon Cables (See Figure 4-13 c
1 ,
c
2
& a
3
)
located on the CPU Board Module and remove
the CPU Board Module from the Transport Unit.
2. Remove the single (1) mounting Screw
(See Figure 4-14 a) and remove the Optional
Extension Memory Board if installed (See Figure
4-14 b) from the assembled Extension Memory
Board.
3. Carefully spread both sides of the PCB Support
apart (See Figure 4-15 a
1
& a
2
) and slide the
Validation CPU Board (See Figure 4-15 d) and
the Controller CPU Board (See Figure 4-15 c) off
of the CPU Board Module.
4. Remove two (2) mounting Screws (See Figure 4-
15 b
1
& b
2
), and separate the Validation CPU
Board and the Controller CPU Board from one
another if they exist separately.
USB FPC, Power FPC & Interface
FPC Cable Removals
To remove the USB FPC, the Power FPC and the
Interface FPC proceed as follows:
1. Remove the two (2) mounting Screws (See Figure
1
& a
2
) retaining the Motor Unit to the
Transport Assembly, and remove the Motor Mod-
ule (See Figure 4-16 b) from the Transport Unit.
2. Remove the USB FPC (See Figure 4-17 a), the
Power FPC (See Figure 4-17 b) and the Interface
FPC (See Figure 4-17 c) from the Transport Unit.
Figure 4-12
RFID Module & Harness Removal
a
2
a
1
b
c
Figure 4-13
CPU Board Module Removal
a
1
a
2
a
3
a
4
b
1
b
2
c
1
d
c
2
c
3
Figure 4-14
Extension Memory Board Removal
b
a
Figure 4-15
Validation CPU Board and Control
CPU Board Removal
b
1
b
2
c
d
a
1
a
2
NOTE: Carefully observe the Up and Down
Fold Line indications shown by the two (2)
Cyan
Arrows in Figure 4-17, and DO NOT
rebend them in an opposite direction!