![background image](http://html1.mh-extra.com/html/jcm-global/ivizion-ld/ivizion-ld_operation-and-maintenance-manual_640273121.webp)
P/N 960-100929R_Rev. 3 {EDP #148849}
© 2012, Japan CashMachine Co., Limited
B - 1
Next-Generation Banknote Acceptor Unit
A p p e n d i x B
B GLOSSARY
A
1
Acceptor
– a term used in Communication Section 3 referencing functions sent to, and
received from the Banknote Acceptor by software commands… See Page 1-1
B
2
Bezel
– a removable Plastic Assembly attached to the front of the Banknote Insertion Slot of
a iVIZION
®
C
3
Calibration
– a process performed on electronic equipment which ensures that all circuits are
properly aligned and operating at optimum levels. For
iVIZION
®
accomplished using a software based program which checks and sets the
operational reference levels for Sensors. This helps to ensure that the Unit
operates with the highest Banknote acceptance rate possible. Calibration is
recommended whenever the CPU Board, or one of the Sensor Boards are
4
ccTalk
– a Serial based Communication Protocol commonly used in control, electronic
payment, and vending systems. Developed by Money Controls Ltd., the format
enjoys widespread use throughout Europe. cc-Talk is supported communications
format in the iVIZION
5
Checksum
– a numerical value assigned to a data file or block of data (usually expressed in
Hexadecimal notation). Checksum values are used to verify that the contents of
a data file are not corrupted in any way during transmission or encryption. The
Checksum values of both the original and duplicate files are compared to each
other. If the values match, then the duplicate file is recommended that file be
copied or encrypted again until the Checksum do agree technique, which is
highly accurate and can detect data errors down to a single computer
6
CIS
– an acronym for Contact Image Sensor. This type of image Sensor is able to scan every
portion of a Banknotes surface as it passes over it… See Page 4-6,4-8 & 4-9
7
CPU
– an acronym for Central Processing Unit… See Page 4-1
D
8
DIP Switch Block –
Dual Inline Packaged Switch Block – a printed circuit board mountable
two-position slide switch package containing up to 16 individual
E
9
External DIP Switch
– a procedure for performing
iVIZION
Calibration using the External
KF srl | www.keyfuture.com | Phone +39 059313920
KF srl | www.keyfuture.com | Phone +39 059313920