JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein phone: +49 7304 9617-0
www.jb-lighting.de
- 45 -
1. SELECT FEATURE (press key of feature selection block)
2. SELECT ON AND OFF VALUES
Enter DMX values for „ON“ and „OFF“.
Use softkeys for Presets, or encoder wheels.
To enter “ON” value press softkey on until it is displayed inverted, then enter DMX value
To enter “OFF” value press softkey off and proceed the same.
3. SELECT DIRECT MODE ON PAGE 2 AND CHOOSE DESIRED UNITS OR SELECT ANY USER
SEQUENCE ON PAGE 2
Switch to page 2 of the chase generator by means of the softkeys „<<<“ or „>>>“.
Activate “DIRECT” mode by pressing the according softkey.
Select the desired fixtures or par-channels by means of the keys in the fixture/par selection block.
4. SELECT PATTERN ON PAGE 3 OR PAGE 4
Switch to page 3 or page 4 to select one of the pre-programmed chase patterns.
Use softkeys to activate pattern.
This small diagramm marks the activated fixtures or par-channels
5. PRESS FLASHING STORE BUTTON FOR CALCULATION
To start the creation of the chase press store-key.
After the chase has been created the LED of the chase key will start blinking, the LED of the store key will
start flashing.
The display will show the PROG COMB MENU and not the chase generator.
To confirm the process press the store-key of combi-section again.
The red LED of the store key will switch off.
10.1.1 The matrix of the chase generator
Each different pattern of the chase generator is displayed in form of a matrix on page 3 and 4 of the chase
generator. The matrix visualizes the „ON“ and „OFF“ values.
An empty square „
£
“ symbolizes the „OFF“ value.
A black square „
¢
“ symbolizes the „On“ value.
The chase step switch from the „Off“ to the „On“ values according to the matrix.
Die hier dargestellte Ablauf-Grafik ist also folgendermaßen zu entschlüsseln:
Example:
For this chase we assume 6 fixtures to be involved.
