JB-lighting Lichtanlagen GmbH Sallersteigweg 15 D-89134 Blaustein phone: +49 7304 9617-0
www.jb-lighting.de
- 17 -
To connect the Licon1 to a MIDI device use a standard 5pin MIDI-cable.
You will find the MIDI-sockets on the back panel of the lighting control consol.
Connect the MIDI-cable to the MIDI-in socket of the Licon1. and to the MIDI-out socket of your MIDI device.
2.7.4 Assign the MIDI channel
MIDI can be send on 16 different channels. Set the Licon1
configuration to the desired channel first.
Enter menu by pressing softkeys CONIFG/MIDI.
Use encoder wheel situated on the right hand side (MIDIDH) to
enter midi channel. The adjusted midi-channel will be shown on
the display.
2.7.5 Assign MIDI notes
Midi-notes can be assigned with a midi-device linked or without one.
It is very important to press softkey DIRECT first. If this softkey is displayed inverted access to all levels of
cues, chases and sequences is obtained. If it is not displayed inverted access only to cue page 1 and bank A
is obtained.
•
Assign midi-notes with a linked midi-device (e.g. keyboard)
Enter midi-menu by pressing softkey CONFIG/MIDI. Then press one of the midi-
keyboards keys. The midi-note will be shown on the display (e.g. G5). Then
press key of the cue/chase or sequence section to assign it to the midi-note.
If softkey DIRECT is displayed inverted access to page 1 to 3, bank A to D is
obtained
There are some midi-notes preoccupied with different cues or chases. If you
want to assign any other key to one of the midi-notes, simply press the desired
key.
•
Assign midi-notes without a linked midi-device
Enter midi-menu by pressing softkey CONFIG/MIDI.
Use encoder wheel which is situated in the middle to recall the midi-notes. Press
one of the keys in cues/chases and sequence section to assign it to the midi-
note
2.7.6 Assign softkeys
