![background image](http://html.mh-extra.com/html/jai/vehicle-imaging-subsystem-300/vehicle-imaging-subsystem-300_installation-manual_631589054.webp)
Page 42
VIS CAM 300/400 Installation Manual
System Set-Up
4.1.11 Flash Head Alignment
The following section provides a general procedure to align the VIS flash head. Be sure to follow any
specific alignment procedure provided with your system.
Align the flash head at night and after aligning the cameras. Park a light colored vehicle underneath the
camera and where the vehicle detector triggers the camera.
•
Press the “Repetitive Trigger” button on the ENSetup toolbar. This will trigger the camera every
second. Make sure that the “Ethernet” external hardware trigger is enabled in the “Camera Proper-
ties” section “2 – Trigger”, property “External Trigger Source”.
•
Adjust the flash head tilt and pan control until the entire back of the vehicle is well illuminated. If
necessary, adjust the flash-head pan control to center the flash beam over the vehicle.
•
If the flash illumination is too bright for your installation, contact JAI for instructions on how to
adapt VIS system parameters to reduce sensitivity to nighttime illumination.
Repeat pressing the “Repetitive Trigger” button on the ENSetup toolbar to stop flash firing. Repeat the
above steps for each camera/flash.
Summary of Contents for Vehicle Imaging Subsystem 300
Page 2: ...Page ii Vehicle Imaging Subsystem 300 400 ...
Page 12: ...Page xii List of Tables ...
Page 114: ...Page 102 VIS CAM 300 400 Installation Manual ...
Page 115: ......