Page 33
VIS CAM 300/400 Installation Manual
System Set-Up
4.1.5 Edit the alignment settings on the Setup Computer
In order to carry out the alignment properly, the ENSetup program has to be configured with two values
from the worksheet. See the ENSetup Program User’s Guide (Video Window Setup section) for details
on changing Video Window properties.
Using the ENSetup program, make sure the “tilt line” and “plate num cols” items on your Portable
Setup computer are exactly the same as the measurements, including the proper plate size parameters
measured in Section 4.1.4, “Validate the Installation Geometry,” on page 32. All other camera settings
should already be correct for the site installation, but it is a good idea to verify that this is true before
proceeding. The Setup Computer is now properly configured to support lens adjustments and camera
aiming.
4.1.6 Connect the Setup Computer to the Camera
•
Position the Setup Computer next to the camera being aligned. If the alignment is conducted in
bright sunlight, shield the monitor screen with a hood to make it visible. Make sure that no portion
of the computer or cables interfere with the camera’s view of the road.
•
Connect the Setup Computer’s network adapter with the camera network. This can be done directly
to the I/O boards X1 and X3 connectors or using a local Ethernet switch. It is preferable to use a
local Ethernet switch instead of a local direct connection to the I/O board. A direct connection
between the Setup computer and the camera will disconnect the camera from the site LAN and
thereby disconnect the light sensor as well.
Summary of Contents for Vehicle Imaging Subsystem 300
Page 2: ...Page ii Vehicle Imaging Subsystem 300 400 ...
Page 12: ...Page xii List of Tables ...
Page 114: ...Page 102 VIS CAM 300 400 Installation Manual ...
Page 115: ......
