JAI Vehicle Imaging Subsystem 300, Installation Manual

Page: 28 / 116

Page 16
VIS CAM 300/400 Installation Manual
Installing the Vehicle Imaging System
FIGURE 11.
TLS-300 signal and power cable.
3.
Route the Traffic Light Sensor end of the TLS-300 signal and power cable through the mounting
pipe and the flange (see Figure 12)
4.
Screw the flange onto the pipe, finger-tight, to allow
subsequent minor adjustment
5.
Attach the cable connector to the Traffic Light Sensor
6.
Attach the Traffic Light Sensor body to the flange and
secure it with the four Allen screws
7.
Orient the Traffic Light Sensor such that the white
reflectors are parallel to the trigger plane with side B
facing (visible from) the trigger plane
8.
Route the free end of the cable to the VIS J-Panel in
accordance with the local code requirements
9.
Connect the color-coded wires to J-Panel connector X3
as described in “X3, X7 Traffic Light Sensor ” on
page 22. Make sure that no power is applied when per-
forming any wiring operation.
FIGURE 12.
Installing the TLS-300 through the mounting pipe and flange.
TABLE 1.
Light Sensor Cables
PIN# Wire color Signal
1 White/green Heater gnd
2 Green Heater gnd
3 Red/blue 24V dc
4 Blue/red 24V dc
5 - nc
6 Yellow +24V dc
7 - nc
8 - nc
9 - nc
10 White Gnd
11 - nc
12 - nc
13 Brown D1-
14 White/brown D1+
15 Orange D0-
16 White/orange D0+
- Black Shlds