![background image](http://html.mh-extra.com/html/jai/vehicle-imaging-subsystem-300/vehicle-imaging-subsystem-300_installation-manual_631589053.webp)
Page 41
VIS CAM 300/400 Installation Manual
System Set-Up
FIGURE 36.
Focus Bar Waveform Display with waveform cursors.
9.
Use one hand to carefully hold the focus ring of the lens in place while you rotate the filter ring on
the very front of the lens with your other hand. Turn the filter ring until the white mark on the ring
is oriented straight up (or down). Secure the filter ring in place with a small dab of RTV glue.
10.
Printout the image of the screen using the “File -> Print…” menus on both the “Video Window”
and the “Focus Bar Waveform” windows to document the settings. If no printers are connected, the
“PDFCreator” printer driver can be used to save the pictures as PDF-files.
11.
Have your assistant move the plate stand back to the near trigger line and re-position the plate at the
minimum plate height.
12.
Drive the setup vehicle slowly towards the trigger line in the same heading as normal traffic flow
and center it directly between the camera being aligned and the adjacent camera that has already
been aligned. Marking the position halfway between adjacent cameras at the trigger line with some
marker is advisable to help the driver properly aim the vehicle.
13.
Park the vehicle at the location where it just barely causes the trigger to cause an image to be cap-
tured. For loop triggers, park the vehicle where a vehicle would normally be located when the loop
trigger signals the VIS to capture an image.
Summary of Contents for Vehicle Imaging Subsystem 300
Page 2: ...Page ii Vehicle Imaging Subsystem 300 400 ...
Page 12: ...Page xii List of Tables ...
Page 114: ...Page 102 VIS CAM 300 400 Installation Manual ...
Page 115: ......